Power Entry Connector
- 4 Pole/5 Wire nylon "locking" flanged inlet
- Delta configuration option available
- See Model Selection Table for Mating Power Connector
Circuit Breaker
- 4 Pole magnetic circuit breaker
- rated for 100% load over temperature
- "medium" trip delay (general purpose applications, Test Equipment,
transformer protection)
Output Receptacles (60 and 400 Hz Models)
- one (1) duplex NEMA 5-20R per phase
- one (1) three phase "locking" receptacle
- one (1) Utility duplex NEMA 5-20R wired to Phase A activated by Main
breaker
Mechanical:
- Dimensions:
- 20/30A Models 19.0" W x 5.25" H x 11.0" D
- 60A Models 19.0" W x 7.00" H x 11.0" D
- Weight: 20 Lbs (30A Model)
- Construction: all aluminum, chromate finish
- Paint: front panel Gray FS 595 #26496
- Mounting holes per EIA 310D
Operating Frequency:
60 Hz PDU Models may be operated at 50 Hz only if
unit is NOT equipped with Optional AC Power Monitor
Contact AC General for Technical Assistance if you require 50 Hz operation.
|
Options:
Remote ON/OFF (Option "R" and "R1")
- Allows remote control of AC Power Controller up to 150 ft. away (60Hz
models only)
- Low voltage control circuit:
- 60Hz Models- 24 VAC
- 400 Hz Models- 24 VDC
- AMP 9Pin "CPC" style connectors both ends
- Two types of Remote Control are available:
- "R" Option System power controlled via (1) lighted toggle switch
- "R1" Option System power controlled via (2) lighted momentary pushbutton switches
AC Power Monitor (Option "P")
- Available in 60Hz and 400Hz PDUs
- "A-B-C" phase rotation protection and AC line UNDER
VOLTAGE/Phase Loss protection.
Under voltage set point is calibrated (-)15% of ph-ph voltage
(Setpoint= 177VAC on 208VAC Phase-to-Phase)
- Automatically removes all switched power upon AC fault detection
within 50 msec
|
